Back To Main

Delamination - Causes, Prevention, Repair

Delamination is primarily caused by finishing the surface of the concrete before bleed water and bleed air has had the chance to escape. This creates "blisters" just under the surface that later break down under traffic. Often the owner is unaware that there is a delamination problem in his/her concrete until wear or traffic begins to break down the surface. Delamination exposes the aggregate which is much more susceptible to damage from weather and salt.

To preserve your concrete from further damage it is vital you apply a good sealer right away. V-SEAL can protect the exposed "blisters" where the aggregate is showing and it can also provide greater strength to the blistered areas that have not yet broken under traffic.

To completely repair the defective areas you might consider patching, new surface overlay, or even epoxy injection. We have a variety of specialty coatings that can help you repair delamination. If you choose not to repair the patches, you should, at the very least, preserve the areas with V-SEAL to help keep your concrete from further breaking down.

Call us toll free at 1-877-738-7325 and we can help you determine the best and most economic solution to your specific delamination issue.

Have some questions? Give us a Call. We can help!


	Toll Free:	1-877-73V-SEAL (1-877-738-7325)
	International:	1-740-389-5720 1-740-389-9600