INDUSTRA-SEAL 117
USES:
Industra-Seal 117 is a superior commercial, water-based product for machine troweled " SMOOTH SURFACES ". It is an excellent call for hardening, dust proofing and sealing of concrete. It is the precise call for concrete floor applications where long term resistance to dusting, black rubber tire marks, abrasion, chemical and water resistance is important. Industra-Seal 117 is a chemically reactive sealer penetrating the surface to become an integral part of the substrate. Industra-Seal 117 is suitable for both interior and exterior applications. Ideal applications include, but are not limited to garage floors, basements, industrial plants, warehouse floors, schools, factories, hospitals, malls, food processing plants, textile mills, freezers, water and sewage treatment plants, parking decks, airports and stadiums.
APPLICATION:
Apply only when temperatures are above 40°F (4°C).
Avoid contact with glass, aluminum and polished metal surfaces. If
contact occurs, wash immediately with water.New Concrete: After finishing
is complete and surface water has disappeared, cure with recommended
sealer (call for instructions), water or properly used sheet materials.
If water or sheet materials are used for curing, use for a minimum
of 3 days. Use only after a minimum of 7 days from concrete pour date.
Old Concrete/Masonry: All surfaces to be treated must
be clean and sound. Remove all membrane forming curing compounds,
sealers, oil, grease, dirt and other contaminants. For best results,
remove any concrete laitance and patch or fix all cracks and damaged
areas. Apply Industra-Seal 117 to point of rejection (by spray, roller,
brush or pouring), working it in using a soft bristle broom or mechanical
scrubber. Work in this manner until the product begins to gel, usually
in 15-30 minutes, then rewet with water and work for another 5-10
minutes. Thoroughly rinse and then squeegee or brush off excess material
until dry. On porous or rough surfaces, a second application may be
required.If a second coat is required, immediately apply it in a similar
manner as the first coat. Do not allow the treated surfaces to dry
between applications. The use of a mechanical scrubber will increase
the effectiveness of the application. The treated surface will develop
a "polished" appearance over time.
DRYING TIME: Approximately 2-4 hrs. at 70°F
(21°C) with good air circulation.
COVERAGE: First Coat 200 sq. ft. per gal. (4.9
m2/L)Second Coat (if necessary) 300 - 400 sq. ft. per gal. (7.4 -
9.8 m2/L)Texture and absorption of surface will determine final coverage
rates. Porous concrete surfaces may require additional material.
LIMITATIONS: Ponded or puddled material must
be squeegeed or brushed, otherwise white residue will appear on the
surface. If white residue starts to appear on the surface during drying,
immediately remove with hot water and scrubbing. Floors are slippery
during application. If Industra-Seal 117 is accidentally applied to
glass, aluminum or polished metal, immediately rinse with water to
prevent etching. Porous or low quality concrete substrates may not
develop a "polished" appearance over time.